Copper was the standard water pipe in Arizona homes for decades, and a lot of it is still doing its job. It is a good material. It is not a forever material, and our hard water and concrete slabs give it a few specific ways to fail.
How to recognize it
Copper is the color of a penny when new and turns dull brown with age. Joints are soldered, so you see a thin silver line where a pipe enters a fitting. The easiest places to look are at the water heater, under sinks and where the main line comes out of the ground at the front of the house. A magnet will not stick to it.
The types of copper tube
| Type | Wall thickness | Where it is used |
|---|---|---|
| Type K | Thickest | Underground service lines |
| Type L | Medium | Water lines inside the home and under slabs |
| Type M | Thinnest | Water lines inside the home, above ground |
The Copper Development Association publishes the technical handbook on copper tube and fittings.
What goes wrong with copper here
- Slab leaks. In many Valley homes the copper lines run under or in the concrete slab. When one of those develops a leak, you cannot see it. The clues are a warm spot on the floor, the sound of running water with everything off, a water bill that jumps, or moisture at the base of a wall. The usual fix is to abandon the line in the slab and reroute new pipe through the attic.
- Pinhole leaks. Copper can corrode from the inside until a pinhole opens. Look for green or white crust on the outside of the pipe.
- Corrosion at joints and fittings. Blue-green staining at a joint means it has been weeping.
- Copper connected straight to steel. Two different metals touching will corrode each other. I see this most at water heaters.
- High water pressure. Pressure over 80 psi is hard on every pipe and fitting in the house. I test it. See missing expansion tanks.
Older copper and lead solder
The pipe is copper, but the solder holding older joints together may contain lead. The EPA says lead pipes, fixtures and solder are more likely to be found in homes built before 1986. A home inspection does not test water for lead. If you are concerned, the EPA explains testing and simple precautions on its page about lead in drinking water.
What I look for
- Corrosion, crust and staining on every visible pipe, fitting and valve.
- Water pressure at a hose bib, and how the flow holds up with several fixtures running.
- Signs of a past reroute: newer pipe in the attic, patched drywall, capped lines at the water heater.
- Moisture at the base of walls and under flooring, checked with a moisture meter and thermal imaging.
- The main shutoff. See gate valves at the main shutoff.
Who to call
A licensed plumber. For a suspected slab leak, ask for one that does leak detection. Check the license at the Arizona Registrar of Contractors. The state’s tolerances for new plumbing work are in Arizona workmanship standards for plumbing.
More Arizona plumbing pipe guides
Water pipe: PEX, CPVC, galvanized steel and polybutylene and Kitec. Gas: gas pipe. Drain pipe: ABS and PVC, cast iron and clay sewer pipe.
Plumbing inspections in Gilbert and across Arizona
The visible plumbing is part of every residential home inspection I do, and a sewer camera inspection shows you the drain line you cannot see. Every home inspection includes a termite (WDO) inspection at no extra charge, and your report is delivered within 24 hours. We inspect homes in Gilbert, Mesa, Chandler and across the Valley. See all of our service areas.
Buying a home? Book your inspection online or call 623-399-0079.


