If the house is fairly new, or an older house has been repiped, the water lines are probably PEX. It is the flexible plastic pipe that has largely replaced copper in new Arizona homes. It is a good product with a short list of things to watch.
What PEX is
PEX is cross-linked polyethylene. It is flexible, so it bends around corners instead of needing a fitting at every turn, and fewer fittings means fewer places to leak. It is usually red for hot, blue for cold, or white or clear for either. Many homes have a manifold, a central panel where each fixture gets its own line and its own shutoff.
The Plastics Pipe Institute is the trade group for plastic pipe and publishes a design and installation guide for PEX plumbing.
PEX compared with copper
| PEX | Copper | |
|---|---|---|
| Corrosion | Does not corrode or build up scale | Can pit and pinhole over time |
| Joints | Few, made with crimp, clamp or expansion fittings | Many, soldered |
| Sunlight | Damaged by it | Not affected |
| Rodents | Can be chewed | Not affected |
| Under the slab | Usually run overhead in the attic instead | Often run under the slab in older homes |
More on the older material in copper water pipes.
What goes wrong
- Sun exposure. PEX is not made to sit in sunlight. In Arizona that matters. Exposed PEX at a water heater outside, at a hose bib or at a water softener loop should be covered or changed to another material.
- Fittings. The pipe rarely fails. The fittings and the connections are where leaks show up, especially a crimp ring that was never fully crimped.
- Kinks. A line bent too sharply restricts flow and can split later.
- Rodents. Roof rats in an attic will chew plastic pipe. See pack rats, roof rats and scorpions in the attic.
- Too close to heat. PEX should not connect directly to the top of a gas water heater or run against a flue.
PEX is not Kitec or polybutylene
Buyers mix these up. Polybutylene is the gray plastic pipe from the 1980s and 1990s, and Kitec is a plastic and aluminum pipe with fittings that corrode. Both have a history of failures. Standard PEX does not share it. Here is how to tell them apart: polybutylene and Kitec, the Arizona pipes that burst.
What I look for
- PEX exposed to the sun anywhere outside.
- Leaks, stains and corrosion at fittings, the manifold and the water heater.
- Kinked, unsupported or rubbing lines in the attic.
- Water stains on attic insulation and ceilings below the pipe runs.
- Water pressure and flow.
- In a repiped house, whether the old lines were properly capped and whether there is a permit. See permits and receipts on a flipped house.
Who to call
A licensed plumber. Check the license at the Arizona Registrar of Contractors. For a new home, plumbing problems belong on your builder’s list at the 11-month warranty inspection, and the state’s tolerances are in Arizona workmanship standards for plumbing.
More Arizona plumbing pipe guides
Water pipe: copper, CPVC, galvanized steel and polybutylene and Kitec. Gas: gas pipe. Drain pipe: ABS and PVC, cast iron and clay sewer pipe.
Plumbing inspections in Gilbert and across Arizona
The visible plumbing is part of every residential home inspection I do, and a sewer camera inspection shows you the drain line you cannot see. Every home inspection includes a termite (WDO) inspection at no extra charge, and your report is delivered within 24 hours. We inspect homes in Gilbert, Queen Creek, Chandler and across the Valley. See all of our service areas.
Buying a home? Book your inspection online or call 623-399-0079.


